Scuba fins allow you to swim faster while in water but make you walk much slower while on land.
These are the highest level of scuba fins which allow you to swim faster than the lower tiers. The other two levels are:
- Scuba Fins (Beginner)
- Scuba Fins (Intermediate)
These are made with lower level polymers.
The scuba fins are equipped in the boots slot in your inventory.
The advanced scuba fins require at least Polycraft Level 7 to make and are made by putting Nitrile-Butadiene Rubber Pellets, Bromine Isobutylene-Isoprene Rubber Pellets, Styrene-Butadiene Rubber Pellets, Hydrogenated Nitrile-Butadiene Rubber Pellets, or Chlorine Isobutylene-Isoprene Rubber Pellets into the hopper of the injection molder with a water bucket and a scuba fin mold, which is shown further below (see Machining Mill - Scuba Fins).
The mold can be made using Bronze Ingots, Cobalt Ingots, Stainless Steel Ingots, Antimony Ingots, Nichrome Ingots, Magnesium Ingots, Nickel Ingots, Bismuth Ingot, Tungsten Ingots, Titanium Ingots, Brass Ingots, Tungsten Carbide Ingots, Platinum Ingots, Manganese Ingots, Aluminum Ingots, Steel Ingots, or Antimony-Lead Ingots.
Only one kind of ingot can be used for each mold.
Nitrile-Butadiene Rubber Pellets
Nitrile-Butadiene Rubber Pellets are the easiest of the 5 pellets to make. To make these, you need to combine acrylonitrile and butadiene in a chemical processor.
To acquire acrylonitrile you need to combine Propylene and Ammonia in a chemical processor.
Propylene can be acquired by distilling crude oil in a distillation column. The tree is as follows:
Crude Oil --> Naptha --> Light Naptha --> Light Olefins --> Propylene
Ammonia can be acquired by combining Nitrogen, Hydrogen, and a Iron III Oxide Catalyst in a chemical processor.
Nitrogen is acquired by placing a condenser anywhere except near a block of water.
see Hydrogen below for how to acquire Flask (Hydrogen)
To acquire butadiene, you need to distill crude oil in a distillation column to get benzene, toluene, or xylene. The tree is as follows:
Crude Oil --> Benzene-Toulene-Xylene --> Benzene, Toluene, and Xylene
Then combine the benzene, toluene, or xylene in the steam cracker with hydrogen in the steam cracker.
Hydrogen can be acquired by combining a Platinum Catalyst with deionized water in a chemical processor.
Deionized Water is acquired by combining salt water with a Platinum Catalyst in a chemical processor. | Salt water cam be aqcuired by placing a condenser adjacent to a source block of water.
||Bag (Styrene-Butadiene Rubber Pellets)
|Crafting Duration (sec)
|Max Stack Size
||Bag (Nitrile-Butadiene Rubber Pellets)
||Bag (Hydrogenated Nitrile-Butadiene Rubber Pellets)
||Bag (Chlorine Isobutylene-Isoprene Rubber Pellets)
||Bag (Bromine Isobutylene-Isoprene Rubber Pellets)