Scuba Fins (Intermediate)
Scuba fins allow you to swim faster while in water but make you walk much slower while on land.
These are the second level of scuba fins which allow you to swim faster than lower tiers. The other two levels are:
- Scuba Fins (Beginner)
- Scuba Fins (Advanced)
These are made with different polymers.
The scuba fins are equipped in the boots slot in your inventory.
The intermediate scuba fins are made by putting 16 bags of isobutylene pellets, 16 bags of polybutadiene (high-cis) pellets, or 16 bags of polybutadiene (low-cis) pellets into the hopper of the injection molder with a water bucket and a scuba fin mold, which is shown further below.
The mold can be made using Bronze Ingots, Cobalt Ingots, Stainless Steel Ingots, Antimony Ingots, Nichrome Ingots, Magnesium Ingots, Nickel Ingots, Bismuth Ingot, Tungsten Ingots, Titanium Ingots, Brass Ingots, Tungsten Carbide Ingots, Platinum Ingots, Manganese Ingots, Aluminum Ingots, Steel Ingots, or Antimony-Lead Ingots.
Only one kind of ingot can be used for each mold. .
Isobutylene Rubber Pellets
There are two simple ways to make isobutylene pellets.
Both of these require butylene isomers to be heated in a furnace in order to receive the pellets.
Butane Isomers and Platinum Catalysts
This method requires you to distill crude oil in a [Distillation Column | distillation column]] all the way to butane isomers. The tree is as follows:
Crude Oil --> Naptha --> Light Naptha --> Light Parrafins --> Butane Isomers.
From this point, you combine the butane isomers with a platinum catalyst in the steam cracker.
|Polymer Pellets||Bag (PolyButadiene (low-cis) Pellets)|
|Crafting Duration (sec)||20|
|Max Stack Size||1|
|Source 1||Bag (Isobutylene Rubber Pellets)|
|Source 2 "||Bag (PolyButadiene (high-cis) Pellets)|